B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Servicing Standard Outside Escutcheon PartsSERVICING THE HARNESS CLAMPRemoving theharness clamp1. Remove the following parts:■ inside and outside escutcheons. For mortise lock instructions,see page 5–3. For cylindrical lock instructions, see page 7–5.■ escutcheon gasket (page 9–2).2. Loosen the electronics board mounting screw that holds the harnessclamp and remove the clamp.Electronics boardmounting screwUpgrade cable(J1)Harness clampPrimary harnessSensor harnessOutside escutcheonFigure 9.3Removing and reinstalling the harness clamp(smart card reader shown)Reinstalling theharness clamp1. Slide the harness clamp under the loosened electronics boardmounting screw.2. Position the primary harness, sensor harness (EV, FV, and LVfunction mortise locks), and upgrade cable under the clamp, asshown in Figure 9.3.Note: For a description of lock functions, see page 2–2.3. Tighten the screw.4. Reinstall the following parts:■ escutcheon gasket (page 9–2)■ inside and outside escutcheons. For mortise lock instructions, seepage 5–6. For cylindrical lock instructions, see page 7–8.9–4 B.A.S.I.S. G Service Manual