B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Servicing Standard Mortise Case PartsAdding key overrideTo add key override, you can convert an LV function lock to anFV function lock or an NV function lock to an EV function lock.Note: For a description of lock functions, see page 2–2.Order these parts/kits and perform the tasks below:■ brass outside escutcheon, part number D62506 (or D62508 for usewith non-BEST cores) or zinc outside escutcheon, part numberC60445 (or C60406 for use with non-BEST cores).■ core, contact your BEST Representative for details■ cylinder, part number B61341 for 1 3/4″–2″ thick doors.See page 2–17 for cylinder part numbers for thicker doors.■ sensor harness kit, part number 1833728 (NV to EV) or 1833760 forthe conversion harness■ sensor module kit, part number 1833885 (LV to FV)or 1833927 (NV to EV)■ clamp plate, part number A35257.1. Remove all of the trim parts from the door, by performing all of thesteps for removing parts in each section of Chapter 5. Begin withthe levers (page 5–2).2. Remove and open the mortise case (page 6–2).3. For LV to FV conversions, remove the sensor module (page 6–16).4. Install the following parts in the mortise case:■ sensor module (page 6–16)■ clamp plate (page 6–19).5. Remove all of the parts from the old outside escutcheon, byperforming all of the steps for removing parts in each section ofChapter 9. Begin with the escutcheon gasket (page 9–2).6. Install all of the parts from the old outside escutcheon into the newoutside escutcheon, by performing all of the steps for reinstallingparts in each section of Chapter 9. Begin with the reader assembly:■ magnetic stripe card reader assembly (page 9–19)■ smart card reader assembly (page 9–22)■ dual validation reader assembly (page 9–25).7. Close and reinstall the mortise case (page 6–2).8. Reinstall all of the trim parts onto the door, including the cylinderand core, by performing all of the steps for reinstalling parts in eachsection of Chapter 5. Begin with the cylinder (page 5–17).B.A.S.I.S. G Service Manual 6–11