B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

TroubleshootingENABLING COMMUNICATIONS WITHOUT A CARD OR PASSWORDIf the card or password is lost or unavailable, you can enablecommunications by pressing the password override button on thecontrol electronics board, which is located on the inside of the outsideescutcheon. This procedure will not affect the user database, history, orlock configuration.CautionBefore you handle the control electronics board or any componenton the control electronics board, make sure that you are properlygrounded using an electrostatic discharge (ESD) protection kit.Touching the control electronics board without proper grounding candamage sensitive electronic components—even if you don’t noticeany static discharge.1. For standard locks, remove the inside and outside escutcheonsfrom the door. For mortise lock instructions, see page 5–3. Forcylindrical lock instructions, see page 7–5.For exit hardware trim, remove the B.A.S.I.S. escutcheon from thedoor. See page 8–13.2. For standard locks, peel back the lower edge of the gasket from theoutside escutcheon to expose the lower portion of the controlelectronics board.For exit hardware trim, remove the following parts from theescutcheon to expose the control electronics board:■ mounting standoffs (page 10–2)■ escutcheon gasket (page 10–3)■ lift finger (page 10–4)■ mounting plate (page 10–6).3. Connect the PDA to the lock:a. Connect the serial cable to the PDA.b. Connect the serial cable to the programming cable.c. Connect the programming cable to the lock’s communicationport. The connector snaps into place.Note 1: For standard locks, the communication port is located inthe bottom of the outside escutcheon.Note 2: When the B.A.S.I.S. escutcheon for exit hardware trim hasbeen removed from the door, the communication port is locatedon the end of the primary harness.B.A.S.I.S. G Service Manual 12–3