B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

Shared Standard and Exit Hardware Trim PartsREADER CONVERSIONThe reader conversion information provided in this section applies toboth standard B.A.S.I.S. Locks and EX Series Exit Hardware Trim. Todetermine whether a lock has B.A.S.I.S. G or B.A.S.I.S. V electronics, seepage 9–10.Converting to amagnetic stripereaderConverting to asmart card readerConverting to a dualvalidation readerTasks to perform forconvertingTo change the reader for a standard B.A.S.I.S. Lock or EX Series ExitHardware Trim to a magnetic stripe reader, order:■B.A.S.I.S. Magnetic Stripe Reader Kit:■ Magnetic Stripe Reader (Track 1) Kit (1837869) or■ Magnetic Stripe Reader (Track 2) Kit (1833445) or■ Magnetic Stripe Reader (Track 3) Kit (1837900)■ B.A.S.I.S. G Magnetic Stripe Control Electronics Kit (1833529).To change the reader for a standard B.A.S.I.S. Lock or EX Series ExitHardware Trim to a smart card reader, order:■ B.A.S.I.S. Smart Card Reader Kit (1833560)■ B.A.S.I.S. G Smart Card Control Electronics Kit (1833644).Since the reader gasket is extremely difficult to remove from theescutcheon in the field, BEST does not recommend conversion to orfrom a dual validation reader by replacing the reader. Contact yourBEST Representative to obtain a complete outside escutcheonassembly.Perform these tasks:1. For standard locks, remove the inside and outside escutcheonsfrom the door. For mortise lock instructions, see page 5–3. Forcylindrical lock instructions, see page 7–5.For exit hardware trim, remove the B.A.S.I.S. escutcheon from thedoor. See page 8–13.4–2 B.A.S.I.S. G Service Manual