B.A.S.I.S. G Service Manual [T63300] - Best Access Systems

FiguresPositioning the smart card reader assembly 9–22Removing and reinstalling the screws for the dual validation reader assembly9–23Removing the dual validation reader assembly from the outside escutcheon9–24Positioning the dual validation reader assembly 9–25SERVICING EXIT HARDWARE TRIM ESCUTCHEON PARTSRemoving and reinstalling the mounting standoffs 10–2Removing and reinstalling the escutcheon gasket 10–3Removing and reinstalling the lift finger (Precision Hardware rim configurationshown) 10–4Removing and reinstalling the mounting plate 10–6Removing and reinstalling the lever return springs 10–8Removing the motor assembly 10–14Rotating the motor assembly gear 10–15Routing the motor harness 10–16Reinstalling the motor assembly 10–17Removing and reinstalling the locking plate 10–18Reinstalling the locking plate 10–19Removing and reinstalling the yoke 10–20Removing and reinstalling the c-clip 10–22Removing and reinstalling the beam and beam roller 10–23Removing and reinstalling the lever assembly 10–24Removing and reinstalling the shear pin 10–26Changing the handing 10–29MAINTENANCERemoving the backup battery (escutcheon for standard mortise lock shown)11–2Reinstalling the backup battery (escutcheon for standard mortise lock shown)11–3Removing the battery door (four-cell door shown) 11–4Removing the battery pack (four-cell pack shown) 11–5Reinstalling the battery pack (eight-cell pack shown) 11–6Reinstalling the battery door (eight-cell door shown) 11–7Removing and reinstalling the battery cover on the battery bracket 11–8Removing and reinstalling the battery pack 11–8Connecting the sensor harness to the electronics board 11–10Removing the V Series sensor switch assembly 11–11xivB.A.S.I.S. G Service Manual