Duality SE Operator's Manual - Solid State Logic

DaWselecting a DaW Channel for plug-In ControlSelect eDIt mode on the Master Control Panel then use the channel sel buttons to choose the channel you wish to edit.The eDIt flag in the channel meter will light. The DAW will highlight the selected channel and the currently selected plugin.Press alt to display the plug-in window.Alternatively, select a channel by double clicking on one of the insert points in the Mix window.Note that due to changes in Pro Tools software following the release of the Avid Command 8 control surface theEDIT key function is only available from the first 8 channels – to select plugins on other channels, use the mouse(or page the channel to faders 1-8).Note also: Bank switching channels leaves the Plug-In Editor with the channel assigned to it. The channel EDITtally will show this.timecode/Bars & Beats/samples DisplayThe on-screen timecode readout can be assigned to display either timecode (SMPTE/EBU), Feet/Frames, Bars/Beats orsamples. This display will follow the setting selection made within your DAW. Please refer to your DAW manual for furtherdetails.plug-In Display ModesThere are three display modes, Insert, parameter and assign, all of which are selected using the soft button assIgnand Insert/paraM buttons below the V-pots.Viewing Current Inserts (Insert Mode)Press the Insert/paraM button till the Insert/paraM box reads Insert; the Plug-in Editor is now in Insertmode. In this mode, the four V-pots represent four insert points on the selected channel. The currently assigned plug-insare displayed above each V-pot. The name of the currently active plug-in will flash. Additional insert points can be displayedusing the paging buttons.The four V-pot push switches can be used to select an insert slot for editing or for plug-in assignment — see below.3-34 Duality se V3 Operator’s Manual