Duality SE Operator's Manual - Solid State Logic

total recallresettInG COntrOlsautomatically reset ControlsA double press on a fader status button, or on set sel or set all, will reset all the non-latching switch functions, busand processing routing and the fader position on that channel strip, channel strips selected on the central routing panel, orall channel strips respectively.Functions automatically recalled are:• Main (A B C) and Track Bus routing• Filter to Input• Dynamics Pre/Post Eq• EQ In/Out• Insert In/Out and Pre/ Post• Aux/Cue On/Off and Source, Cue B and Pre/Post, plus EFX reassign• Solo Isolate• Fader Position• Channel Cut• Offline TrimManually reset Controls and auto-scanAll latching switches and rotary pots must be reset manually. The ascan (auto-scan) softkey can be used to highlightwhere manual resets are required – when pressed, the console scans all the channels, starting from Channel 1, until it findsa discrepancy. Correctly reset channels are indicated by their green fader status LED being lit; the first channel with anydiscrepancies is indicated in the centre section TFT screen, as well as by its green fader status LED flashing and its TRdisplay appearing in its bay’s TFT screen. Once the discrepancy has been corrected, auto-scan will continue scanning theremaining channels and the centre section.COpyInG anD swappInG settInGsStored TR Setups can be copied or swapped between channels. The CS softkey is used to select the Copy/Swap functionbetween Cs (no function), Copy and swap. Once this button is in the appropriate state, hold down the fader statusbutton on the source channel and press the fader status button on the destination channel. The source channel will becopied to (or swapped with) the destination channel.Note that this function does not overwrite the original Total Recall data – changes are reflected in RAM only.4-6 Duality se V3 Operator’s Manual