Duality SE Operator's Manual - Solid State Logic

Console OperationsChannel Output (CHOp)The Channel Output (D-connector) is normally used to feed the DAW input. The default signal is apost channel fader feed, but the srC sel button can be used to select alternative sources: prechannel fader (pre the SPLIT point — see below), the channel input (also pre the SPLIT point), or anactive EFX send (see below). Each selection is graphically displayed on the channel TFT screen (seeChannel Metering for more information).When either the channel input or pre fader source is selected, the splIt button activates the SplitMonitoring function and routes the DAW return into the channel signal path post the split point (seebelow).Use the associated aFl button to monitor the channel output source as you toggle through theoptions with the srC sel button. The central routing panel has single button selection of the fourchannel output sources: Input, pre FaDe, pOst FaDe and eFx.split ModeWhen the channel output (DAW input) is sourced from either the channel input or pre the channelfader, the splIt button (at the top of the panning area for the channel strip) offers a new approachto in-line tracking on an analogue console by returning the DAW output back into the channel pathjust after the channel output pick off point. By using Input or pre FaDe as the channel outputsource, clean or processed signals are routed to the DAW input, with the option to use the remainingchannel processing and routing to monitor the DAW return in the analogue domain.The effect of SPLIT is graphically illustrated on the channel TFT (see Channel Metering formore information).Note that SPLIT is disabled if CHOP is sourced from POST FADE or EFX, or if the Line Ampis selected as the channel input.2-8 Duality se V3 Operator’s Manual