Duality SE Operator's Manual - Solid State Logic

More documents

Recommendations

Info

Console OperationsMisc OptionsA number of useful options can be accessed via the MISC menu. Press the MIsC button above the display to produce thefollowing options:C0dBM0dBInDOFFunDOSets all channel faders to 0dB.Sets all group master faders to 0dB.When selected, pressing any fader’s fader button will set that fader to 0dB. The InD button flashes toindicate that it is active.Moves all faders to –∞.Reverses the last action.Note that there is one level of undo. The button lights to indicate that an ‘undo’ is available.2-34 Duality se V3 Operator’s Manual
Console OperationsCommunicationsA group of communications buttons (talkback etc.) are fitted below the centralrouting panel. A built-in talkback microphone and pots to set the level of tBto Foldback, talkback Out (an external talkback feed), slate level(talkback to Main Mix, Track bus and channel outputs) and an incoming Listenmic, are provided in the ‘Comms’ section above the DAW control TFT screen(see right).Note that a gain control for the talkback mic preamp is provided on theconnector panel adjacent to the external talkback output jack. If required, anexternal talkback mic may be connected to the console’s talkback distributioncircuitry via an XLR on the connector panel. When using this facility, turn theconsole mic preamp gain fully anticlockwise (off) if you no longer wish theinboard mic to contribute to the talkback system.Note also that, apart from slate, which cuts the monitors, all the followingfunctions dim the monitors. All the buttons, apart from lIsten and reDlIGHt, can be selected to be latching, momentary or to be inhibited in Playor Record – see opposite for details.slate — Interrupts the Main Mix and Track bus outputs with talkback.F/B a and F/B B — Adds (or optionally replaces) talkback to the associated foldback outputs after the level and cutcontrols.ext t/B — Sends talkback to an external feed, available via a 1/4" jack on the connector panel. Level is adjusted usingthe talkback Out pot (see above).tB all feeds talkback to the foldback sends and the external talkback output.lIsten — Injects an external mic signal (connected via an XLR on the centre section connector panel) onto the Mini Aloudspeaker set and dims the main loudspeakers. This button is latching (optionally inhibited in Play or Record); the levelis adjusted using the listen pot (see above). The mic is usually placed in the recording area. The circuitry features SSL’slegendary listen mic compressor, the sound of which is much loved by many experienced SSL users, so the connector panelprovides a post compressor output XLR — ‘Listen Mic Out’.reD lIGHt — this provides an isolated contact closure for hooking up to a studio red light via an external relay box.The talkback button functions are all duplicated on a Talkback/GPIO connector on the rear of the console, as arethe monitor CUT and DIM switches. See the Duality SE Installation Manual for more information.Duality se V3 Operator’s Manual2-35
Page 1:
Solid State LogicS O U N D V I S I
Page 4 and 5:
Manual ContentsFader Grouping 2-12F
Page 6 and 7: Manual ContentsWorking with DaW aut
Page 8 and 9: Manual ContentsseCtiOn 6: reMOte Br
Page 10 and 11: This page is intentionally almost b
Page 12 and 13: IntroductionThis page is intentiona
Page 14 and 15: IntroductionCreative Versatility•
Page 16 and 17: IntroductionThis page is intentiona
Page 20 and 21: Console OperationsThis page is inte
Page 22 and 23: Console OperationsSignal Processor
Page 24 and 25: Console Operationsan Introduction t
Page 26 and 27: Console OperationsAbove each bay of
Page 28 and 29: Console Operationsrel/HOlD — This
Page 30 and 31: Console OperationsChannel Output (C
Page 32 and 33: Console OperationsChannel panAt the
Page 34 and 35: Console OperationsMaster Channel Fa
Page 36 and 37: Console OperationsTo edit any exist
Page 38 and 39: Console Operations12342-16 Duality
Page 40 and 41: Console OperationsCentral routing p
Page 42 and 43: Console OperationsMain Output Funct
Page 44 and 45: Console OperationsMaster FaderThe m
Page 46 and 47: Console OperationsIf either MInI a
Page 48 and 49: Console OperationsMonitor OptionsA
Page 50 and 51: Console OperationsMonitor speaker C
Page 52 and 53: Console OperationsMonitor level Dis
Page 54 and 55: Console OperationsCue/Fx send Maste
Page 58 and 59: Console OperationsThe following opt
Page 60 and 61: Console OperationsMix reassign Matr
Page 62 and 63: Console OperationsCentre section Me
Page 64 and 65: Console Operationssetup MenuThe cen
Page 66 and 67: Console OperationsDaw setupThe next
Page 70 and 71: DaWplug-In editor 3-33Plug-In Edito
Page 72 and 73: DaWThis page is intentionally almos
Page 74 and 75: DaWConsole FocusThe console can be
Page 78 and 79: DaWConnecting via physical MIDI por
Page 80 and 81: DaWsetting your workstation(s) to c
Page 82 and 83: DaWlogic pro 8When Logic is assigne
Page 88 and 89: DaWDaW utility Buttons (9)This grou
Page 92 and 93: DaWChannel solo and Cut panelsChann
Page 94 and 95: DaWselect ModeWith the sel button (
Page 100 and 101: DaWOther useful transport modesHalf
Page 102 and 103: DaWselection Mode (Zoom/sel button
Page 106 and 107:
DaWselecting a DaW Channel for plug
Page 108 and 109:
DaWComparing your ChangesPressing t
Page 110 and 111:
DaWedit tools MenuEdit Tools (edts)
Page 112 and 113:
DaWThis page is intentionally almos
Page 114 and 115:
DaWautomation status DisplayPressin
Page 116 and 117:
DaWThis page is intentionally almos
Page 118 and 119:
DaWThe majority of DAW functions ar
Page 120 and 121:
DaWthe logic templateDuality SE emu
Page 122 and 123:
DaWnuendo/Cubase templateAs with ot
Page 124 and 125:
DaWDuality se’s nuendo Control sc
Page 126 and 127:
DaWCHannel is unchanged and assigns
Page 128 and 129:
DaWThe Transport Control buttons ar
Page 130 and 131:
This page is intentionally almost b
Page 132 and 133:
total recallThis page is intentiona
Page 134 and 135:
Page 136 and 137:
total recalltOtal reCall anD prOjeC
Page 138 and 139:
total recallrecalling a tr setupWit
Page 140 and 141:
total recallresettInG COntrOlsautom
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
automationThis page is intentionall
Page 148 and 149:
automation5-ivDuality se V3 Operato
Page 150 and 151:
Page 152 and 153:
automationworking with projects and
Page 154 and 155:
Page 156 and 157:
automationCreating a new Mix passTo
Page 158 and 159:
automationMix runningPress play on
Page 160 and 161:
automationJoin and reviseAt any tim
Page 162 and 163:
automationprotection ModesEach comp
Page 164 and 165:
automationswitch automationPressing
Page 166 and 167:
automationtrim lokTrim Lok (only av
Page 168 and 169:
automationCopy and swapCopy and Swa
Page 170 and 171:
automationautomation setup OptionsT
Page 172 and 173:
automationTo set up MMC locates, se
Page 174 and 175:
Page 176 and 177:
automationsetup GuidelinesFor A-FAD
Page 178 and 179:
Page 180 and 181:
Page 182 and 183:
emoteThis page is intentionally alm
Page 184 and 185:
Page 186 and 187:
emoteConnecting Duality se to the C
Page 188 and 189:
emoteBacking up a projectTo create
Page 190 and 191:
emotetOtal reCall taBHere you can r
Page 192 and 193:
emoteexternals taBThis page allows
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Block DiagramsThis page is intentio
show all

Duality SE Operator's Manual - Solid State Logic

Create successful ePaper yourself

Delete template?

Save as template?