Duality SE Operator's Manual - Solid State Logic

DaWsend ModeSelect the senD button on the Master Control Panel, and the V-pots become level controls for any sends or aux sendlevels within the DAW.The Master V-pot (2) selects which of the available sends (A – E or 1 – 5) is being controlled by the channel V-pots. Theselected send is shown in the display window above the Master V-pot (and on the channel V-pot scribble strip). The channelscribble strips show the name of the currently selected send. Turning a channel V-pot will alter the level of the selected sendfrom that channel. Holding down the alt button allows you to make fine adjustments to the gain. See over the page onhow to use faders to set send levels.setting sends pre/post FaderWhen working with sends it is useful to be able to flip a send between pre and post fader. If necessary, first select thepre/pOst button (4) on the Master Control Panel. Pushing a channel V-pot will now switch the selected send on thatchannel between pre and post. The green LED below the V-pot lights to show pre is selected.To change mode on all channels, press and hold the Master Control Panel OptIOn button then press any channel V-pot.All channels will switch to pre or post.Muting a send OutputTo mute a send output, select the Mute button (4) on the Master Control Panel and push the channel V-pot. The LEDbelow the channel V-pot will light to show the channel is muted. To mute or un-mute all channels, press and hold theOptIOn button then press any channel V-pot.Flipping send levels to the FadersTo flip send levels from the V-pots to the channel faders, press the Master V-pot (2) — hence push to Flip! The channelfaders now control send levels and the fader Cut button will mute a send. The channel V-pot controls panning on stereosends.In this ‘flipped’ mode, pre/pOst mode is automatically selected for the V-pot switches, so pushing a V-pot will togglethe send pre/post on that channel. The LED below the V-pot lights to show pre is selected.Note that the fader sOlO button will still solo the channel, not the send.Duality se V3 Operator’s Manual3-23