Duality SE Operator's Manual - Solid State Logic

DaWlogic pro 8When Logic is assigned to one of the two layers a Mackie Control together with a Mackie Control Extender must be addedto the Logic Pro Preferences/Control Surfaces Setup menu as shown below:Duality SE Faders 1 – 8 are mapped to the Mackie Control ports along with the Master Fader and workstation Controlfunction switches. Duality SE Faders 9 – 48 are mapped to the Mackie Control Extender ports. The actual ipMIDI ports usedwill depend on which layer (or layers) Logic is assigned to. See the list of Duality SE MIDI port assignments for details. It isessential that the layout shown is followed. If the physical arrangement is reversed, then the Duality SE faders will not mapcorrectly to the on-screen faders in Logic. A maximum of 48 faders (6 Mackie Controls ) can be configured on each layer.If the protocol is set to logic Handshake, Logic should automatically detect the six virtual controllers which will beshown in the Logic Setup menu (as shown above), with the appropriate Duality SE ipMIDI ports assigned. If Logic fails todetect the control surfaces, then the controllers can be added manually via the New/Install menu and the appropriate MIDIOut port and Input assigned. As described above, normally only one layer should be set to Logic Handshake.Note that Logic may detect MTC/MMC connections as a fourth virtual controller.Full details can be found in the online Logic Pro 9 Control Surfaces Support guide in the Logic Help Menu.3-10 Duality se V3 Operator’s Manual