Duality SE Operator's Manual - Solid State Logic

automationTo set up a new link, scroll to new link and press the V-pot push switch. This will create a new entry in the list suffixedwith a number. This entry will be automatically highlighted, and faders can be added to (or removed from) the link bypressing their fader status buttons. Link numbers are shown in the fader scribble strip and the red fader status LEDS willindicate those faders in the currently selected link.To adjust balance of a link, hold one fader whilst moving another. This automatically isolates the second fader from the linkwhilst the remaining faders continue to track the first fader touched.When the Links page is not active, pressing the shOw lInKs button to the left of the Eyeconix button causes the Linksto be displayed in the Scribble Strip.The SHOW LINKS button is automatically selected when the Links page is active.As far as the automation system is concerned, switch and fader operations performed in one channel will cause that functionin every channel in the link to go into Write. Links can be dissolved at any time, but all the automation data will still playout correctly.To edit any existing links, scroll to and select the link. Channels can be added or removed as described above.suspdsel/suspdallLinks can be globally or individually suspended at anytime. A link that is suspended will allow you to move all the faders inthe link independently. If a link is highlighted, then the suspdsel key will deactivate the selected link and ‘suspended’ willbe shown next to the link number. suspdall suspends all links in the list. The ‘Motors Off’ function automatically activatesthe suspdall function.Inverting switch linksTo invert the state of any switch in a link suspend the link, press the switch to toggle it to the opposite state, then re-enablethe link.Deleting linksTo delete a link, select and highlight it, then use the Delete and Confirm keys.saving Mix passes to your Daw projectMix Passes are stored in Duality SE’s internal flash memory when you ‘End’ a Mix; each pass is saved in the Mixes folder inthe current Title. They can be backed up as part of a console Project – see Section 6.Duality se V3 Operator’s Manual5-21