Duality SE Operator's Manual - Solid State Logic

Console OperationsDaw setupThe next few items in the setup menu are concerned with DAW interconnection, but are included here for completeness;see Section 3 for more details. Note that changes to any of these DAW settings will require a console reboot before theytake effect: hold down the restart softkey and press the Confirm softkey which appears to its right.transport lock layer*: Select the master DAW layer for transport control between DAW 1,DAW 2 or Off.Daw 1 Jog wheel sends:MIDI connects via: **Daw 1:Daw 2*First physical channel Daw 1:Channel Count Daw 1:Define the control data sent by the jog wheel for HUI DAWs. Normally theJog Wheel has no action unless Scrub or Shuttle are enabled.The Nudgeoption allows the Jog Wheel to scroll through the session Timeline using thenudge (+/–) commands. Options are Jog / Nudge (40 / 20 / 13 / 10 / 8 / 6 / 5per revolution). The Scroll action depends on the nudge value set in ProTools and the number of commands sent per a jog wheel revolution; adjustto taste. When DAW 2 is HUI, there is a Daw 2 Jog wheel sends*:menu entry.Select the ports used for MIDI connections: MIDI Ports (the physical MIDIports on the console) or Network (MIDI over Ethernet).Select from Protools HUI / Logic / Logic Handshake / Nuendo / DigitalPerformer / SonarSelect from Protools HUI / Logic / Logic Handshake / Nuendo / DigitalPerformer / Sonar / NoneSelect the console channel number that is controlling the first track numberon DAW 1. When DAW 2 is assigned, there is a First physical channelDaw 2*: menu entry.Select the total number of channels dedicated to DAW control (8 – 48 insteps of 8). When DAW 2 is assigned, there is a Channel CountDaw 2*: menu entry.single layer*:Assign both DAWs to a single layer (ON/OFF).* Not displayed if MIDI connects via: MIDI ports is selected.** Only displayed if the DualitySE software features have been enabledDesk settingsscribble strip Brightness Use this to adjust the channel scribble strip brightness (range: 1-6)tFt Backlight Brightness Use this to adjust the backlight level (range: 1 – 8)turn Off Display afterShuts off the TFT display after a predetermined time: 30 mins to 5 hours in30 minute increments.Console Channel CountShould be set to the size of your console: 24, 48, 72 or 96. This settingdetermines the range of channels selected by the Central Routing Panel’sall button.Note that TFT and scribble strip displays can each be turned off by turning the control pot clockwise (beyond 8or 6) to ‘Off’.2-44 Duality se V3 Operator’s Manual