Duality SE Operator's Manual - Solid State Logic

DaWConsole FocusThe console can be selected to one of two important modes using the Console Focus button (8), located on the MasterControl Panel. This switches the channel meters, faders, solo and cut buttons between control of the analogue signal pathand the DAW. When the Console Focus button is illuminated, Duality SE is in ‘Analogue Focus Mode’. When the ConsoleFocus button is not illuminated, Duality SE is in ‘DAW Focus Mode’. This section describes operation of the console in DAWFocus Mode.Note that channel meters can be locked to either the analogue or DAW metering via the METERS soft keys onthe monitor panel: DAW locks the channel meters to the DAW layers, and Anl locks the channel meters to theanalogue channels.analogue Focus ModeThe channel faders control the channel audio output level for that fader. The channel meters indicate analogue input/outputlevels for that channel. The channel V-pots are available to control DAW parameters.DaW Focus ModeThe channel faders control DAW fader levels. The meters indicate DAW track levels. The channel V-pots are available tocontrol other DAW functions such as pan or send level.Digital ‘In-line’ ModeWhen the console is in DAW Focus Mode, analogue level control can be assigned to the V-pots by pressing theCHannel button (1) on the Master Control Panel.Virtual ‘In-line’ ModeWhen the console is in DAW Focus Mode, analogue level control can be assigned to the V-pots by pressing theCHannel button (1) on the Master Control Panel. In Analogue Focus mode, the converse occurs with the V-Potscontrolling the DAW faders levels. In either Focus mode, the V-Pot switch acts as a 'Fader Flip' reversing the assignmentsof the V-Pot and Fader. This mode emulates a traditional In-Line architecture with the DAW console as a fully automatedand instantly resettable monitor mixer.3-2Duality se V3 Operator’s Manual