Duality SE Operator's Manual - Solid State Logic

DaWConnecting via ipMIDIFor information regarding the configuration of network connections, please see the Duality SE Installation Manual.In the ssl / Misc / setup menu, accessible via the centre section TFT, the following options should be selected.Toggle the MIDI connects via: setting to network. Your console will now communicate with your workstation viaEthernet.Ensure that the DaW1 option (workstation layer 1) and DaW2 (workstation layer 2) are set to match your workstationor workstations if you are using the second layer:DaW 1:DaW 2:Select from Pro Tools HUI / Logic / Logic Handshake / Nuendo / Digital Performer / SonarSelect from Pro Tools HUI / Logic / Logic Handshake / Nuendo / Digital Performer / Sonar / NoneThe MCU protocol supports automatic detection of connected control surfaces. To enable this selectlogic Handshake for the appropriate layer. Logic will then automatically detect Duality SE. If you select logicHandshake on both layers then Logic will detect 12 control surfaces, which may not be what you want! The otherprotocols do not transmit handshaking messages.The DaW 2 switch toggles the front panel controls between the two DAWs.It is possible for both DAWs to appear on different channel ranges within DAW layer 1. To do this, ensure that the channelrange for DAW 2 starts after the range for DAW 1 and toggle the single layer option to On. The DaW 2 button inthe centre section will now switch centre section control between the two DAWsWhen using multiple DAWs, one DAW needs to be made the transport master, allowing the other DAW’s transportcontrols to be locked to it via ReWire or MIDI timecode. To simplify operation in this mode the desk transport controlscan be locked to one DAW regardless of which one is currently selected. This is done in the ssl / Misc / setup menuby toggling the transport lock layer: option between OFF (the DAW on the currently selected layer will becontrolled), DaW 1 (desk transport controls DAW 1) or DaW 2 (desk transport controls DAW 2).Note that changes to any of these settings will require a console reboot before they take effect: hold down the restartsoftkey and press the Confirm softkey which appears to its right.Duality se V3 Operator’s Manual3-7