Duality SE Operator's Manual - Solid State Logic

DaWCOnneCtIng DualIty se tO DaWsDuality SE communicates with connected DAWs using MIDI ports – either MIDI over Ethernet (ipMIDI) or the physical MIDIports located on the rear of the console. This is selected in ssl / Misc / setup / MIDI connects via.A number of items in the ssl / Misc / setup menu, accessed via the centre section TFT, are concerned with DAWinterconnection.To change a setting, use the left hand V-pot to select the item, then press the V-pot to enter adjustment mode. Turn theV-pot to the desired setting and press it a second time to save the setting to non-volatile memory.DaW 1 Jog wheel sends: Define the control data sent by the jog wheel for HUI DAWs. Normally the JogWheel has no action unless Scrub or Shuttle are enabled.The Nudge option allowsthe Jog Wheel to scroll through the session Timeline using the nudge (+/-)commands. Options are Jog / Nudge (40 / 20 / 13 / 10 / 8 / 6 / 5 per revolution).The Scroll action depends on the nudge value set in Pro Tools and the numberof commands sent per a jog wheel revolution; adjust to taste.First physical channel DaW 1: Select the console channel number that is controlling the first DAW track numberfor DAW 1.Channel Count DaW 1: Select the total number of channels dedicated to DAW 1 control. Options are 8to 48 in steps of 8 (32 channels max for HUI Controlled DAWs). If you changethese figures, you will need to change the number of controllers assigned in theDAW.Note that these entries also exists for DAW 2 where applicable.single layer: Allows both DAWs to appear on different channel ranges within DAW layer 1.Ensure that the channel range for DAW 2 starts after the range for DAW 1.Note that changes to any of these settings will require a console reboot before they take effect: hold down the restartsoftkey and press the Confirm softkey which appears to its right.Refer to your DAW manual for information on how to configure its software. Once configured and connected,communication with the DAW will be initialised, and the level of Duality SE’s channel faders, rotary controls and masterfunctions will be set to match the DAW controls (provided you are ‘DAW Focus’ mode).Duality se V3 Operator’s Manual3-5