Duality SE Operator's Manual - Solid State Logic

DaWThe majority of DAW functions are controlled via dedicated Duality SE front panel switches, with less reliance than the HUIprotocol on the 8 x 8 soft key matrix located beneath the TFT screen. All plug-in editing is via the channel V-pots. The fourencoders, together with the six switches below the centre section monitor screen, are not used.On the channel fader strips, the fader button and associated status LEDs are also not implemented by the protocol. Allother controls, the V-pot and associated push switch, DAW channel Solo and Cut, plus the Select and Ready functions, areall fully supported. Only mono metering information is returned from the workstation. On stereo channels, the maximumvalue of the left or right channel is displayed. The master fader is also included in the DAW layer when a Mackie Controltemplate is active.The autO, pre, In, Out etc. group of centre section buttons provide different related motion control functionsaccording to the active template.The jog wheel, together with the sCruB button, plus the cursor buttons and cursor mode switch, are active in alltemplates. The outer jog wheel ring is not supported, neither is the numeric keypad. However the 1 – 8 keys replicate F1 –F8 function keys in certain templates.3-46 Duality se V3 Operator’s Manual