Duality SE Operator's Manual - Solid State Logic

automationsnap Modesnap mode uses the fader touch sensor to control both the start and end of a fader update — for fast hands-on changesto mix levels. When the fader is released, it ramps back to the previous mix level at a user-determined rate (see GlideFrames), then returns to Replay.Snap mode can be overridden on any channel by pressing the fader button while still touching the fader knob. On releasingthe fader, the channel while stay in Absolute or Trim until a subsequent fader button press returns the channel to Replay.This write/replay transition will include the ramped Snap glide if enabled in the setup menu (see Glide Frames for moredetail).autotakeoverTo avoid a level jump when dropping out of Write, autotakeover introduces nulling indication arrows to display thedirection to move the fader to match the underlying mix level. When autotakeover has been selected, these nullingindicators can be displayed in the scribble strip for channel faders, and in the Centre Section TFT screen for Group andMaster faders, by pressing the channel’s the fader status button. When the fader crosses the current mix level, it isautomatically returned to Replay and disconnected from the audio gain element. The fader returns to following the mix dataas soon as it is physically released.Offline trimIt is possible to trim the overall level of a channel fader without affecting the underlying automation data. To do this, pressthe OFFlIne trIM button in the AUTOMATION group, and use the channel V-pots to trim the channel gain. When atrim has been introduced, the OFFlIne trIM button flashes and the LED below the relevant V-pots lights. This level isstored and can be recalled via the console TR setup, as described in Section 4.To reset all Offline Trims to 0dB, press and hold the OFFlIne trIM button. To reset individual channels. to 0dB pushthe V-pot switch.Duality se V3 Operator’s Manual5-19