Duality SE Operator's Manual - Solid State Logic

DaWCHannel is unchanged and assigns Duality SE’s channel gain element or DAW channel to the V-pot according to thestate of the Console Focus button. The encoder switch is used to ‘flip’ parameters onto the faders as before, but includesall processing parameters not just send levels.The transport control buttons are designated as shown below:Tallies are provided for all switches,Keypad is not a direct MCU function but it will enable the numeric keypad 0 – 9 keys plus the ‘.’, ‘–‘, ENTER and CLR keysfor data entry. When operated, it send the codes that correspond to M1 ON, EDIT ON, EDIT OFF, M1 OFF and thenenables the numeric keypad keys to send the MIDI codes that correspond to the 1 to 8 keys on the Sonar overlay and the4 TRACKS keys. ENTER mimics the main enter key, and CLR the CanCel key. A second operation of the KeypaDbutton inhibits the numeric keypad from outputting MIDI codes, and should send an EDIT ON, EDIT OFF command to cancelthe mode.Duality se’s sonar Control screenThe 8x8 menu button matrix is used to access three Sonar MCU function groups:Fkys provides access to the eight functions keys. These are defined in Sonar and also output Edit commands in conjunctionwith a Modifier key.autO calls up three automation functions, Snapshot, Disarm and Offset. The main automation Read/Off key is mappedto a dedicated front panel button.trks provides the four TRACKS functions on the bottom row of soft buttons.3-54 Duality se V3 Operator’s Manual