Lists 11/2003 Edition

11.03 2 Machine and Setting Data2.8 Setting data42400 PUNCH_DWELLTIME N4s Dwell time for punching and nibbling SW 3Display filters: -Fct.: Nibbling 1.0, 0.0, 0.0, 0.0, 0.0, 0.0,0.0, ...IMMEDIATELY0.0 plus DOUBLE 7/742402 NIBPUNCH_PRE_START_TIME N4s Delay time (punch/nibble) with G603 SW 4.1Display filters: -IMMEDIATELYFct.: Nibbling .02, 0.0, 0.0, 0.0, 0.0, 0.0, 0.0 plus DOUBLE 7/70.0, ...42404 MINTIME_BETWEEN_STROKES N4s Minimum time between 2 strokes in seconds SW 5.2Display filters: -Fct.: Nibbling 0.0, 0.0, 0.0, 0.0, 0.0, 0.0,0.0, ...IMMEDIATELY0.0 plus DOUBLE 7/742440 FRAME_OFFSET_INCR_PROG K2- Traversing from zero offset with incr. programming SW 4.3Display filters: -IMMEDIATELYalways 1 0 1 BOOLEAN 7/742442 TOOL_OFFSET_INCR_PROG W1- Traversing from zero offset with incr. programming SW 4.3Display filters: -IMMEDIATELYalways 1 0 1 BOOLEAN 7/742444 TARGET_BLOCK_INCR_PROG K1- Set down mode after search run with calculation SW 4.3Display filters: -IMMEDIATELYalways 1 0 1 BOOLEAN 7/742450 CONTPREC B1, K6mm Contour accuracy SW 3.2Display filters: -IMMEDIATELYalways 0.1, 0.1, 0.1, 0.1, 0.1, 0.1, 0.000001 999999. DOUBLE 7/70.1, ...42460 MINFEED B1, K6mm/min Minimum path feedrate for CPRECON SW 3.2Display filters: -always 1., 1., 1., 1., 1., 1., 1., 1.,1., ...IMMEDIATELY0.000001 999999. DOUBLE 7/742465 SMOOTH_CONTUR_TOL B1mm Maximal contour tolerance on smoothing SW 6.1Display filters: -Fct.: Polynomial 0.05, 0.05, 0.05, 0.05,0.05, 0.05, ...IMMEDIATELY0.000001 999999. DOUBLE 7/742466 SMOOTH_ORI_TOL B1degrees Max.angle tolerance tool orient.on smooth. SW 6.1Display filters: -Fct.: Polynomial 0.05, 0.05, 0.05, 0.05,0.05, 0.05, ...IMMEDIATELY0.000001 90. DOUBLE 7/7© Siemens AG, 2003. All rights reservedSINUMERIK 840D/840Di/810D SIMODRIVE 611 digital Lists (LIS) – 11.03 Edition 2-321