Lists 11/2003 Edition

11.03 3 Variables3.2 System datamaskToolManagement $MN_MM_TOOL_MANAGEMENT_MASKSettings for NCK tool management functionActivation of tool management memory with "0" means: The set tool management data do not occupy any memoryspace.Bit 0=1: Memory for TM-specific data is made availableBit 1=1: Memory for monitoring data is made availableBit 2=1: Memory for user data (CC data) is made availableBit 3=1: Memory for "Consider adjacent location" is made availableSW 5.1 and later:Bit 5=0: Parameters and function for tool wear monitoring are not available.Bit 5=1: Parameters and function for tool wear monitoring are available and, if bit 1 = 1, the wear monitoring functionis also available.Bit 6=0: The wear group function is not available; i.e. parameters $TC_MAMP3, $TC_MAP9 cannot beprogrammed, $TC_MPP5 is not defined for magazine locations of type 1.Bit 6=1: The wear group function is available; i.e. parameters $TC_MAMP3, $TC_MAP9 can be programmed andwear groups defined. $TC_MPP5 contains the wear group number for location type 1.Wear group number:Bit 7=1: Tool adapter data sets are available.Bit 8=1: Total offsets are available.Bit 9=1: Tools in a turret are handled in OPI variable modules such that they are not "displayed" in tool halflocations,but always displayed in a turret location. Please note, therefore, that tools in a turret remain (in displayterms) in their turret location in the event of a tool change.Bit 9=0: Default response; Tools in a turret are "displayed" in the OPI in their actual (according to data) location.- 0 Long IntegerMulti-line: yes 1maxCuttingEdgeNo $MN_MAX_CUTTING_EDGE_NOMaximum value of D number1 to 32000- 9 1 32000 UWordMulti-line: yes 1maxNumAdapter$MN_MM_NUM_TOOL_ADAPTERMaximum number of tool adapter data sets available in NCK>0: Maximum number of adapter data sets.0: Adapter data cannot be defined. Edge-specific parameters $TC_DP21, $TC_DP22, $TC_DP23 are available,i.e. active tool management function with adapters is not in use.-1: An adapter is automatically assigned to each magazine location, i.e. the number of adapters providedinternally corresponds to the number of magazine locations set in machine data$MN_MM_NUM_MAGAZINE_LOCATION.- 0 -1 600 Long IntegerMulti-line: yes 1maxnumAlarmsSize of NCK alarm buffer (maximum number of pending alarms)- UWordMulti-line: nomaxnumChannelsMaximum number of available channels- UWordMulti-line: nomaxnumContainerMaximum number of available axis containers- 0 UWordMulti-line: yes 1 1© Siemens AG, 2003. All rights reservedSINUMERIK 840D/840Di/810D SIMODRIVE 611 digital Lists (LIS) – 11.03 Edition 3-345