Lists 11/2003 Edition

3 Variables 11.033.11 Diagnostic dataNon-cyclic events referred to channel control:6 = NC_START NC Start (if detected in NC)7 = NC_STOP NC Stop (if detected in NC, axes maycontinue to move)Non-cyclic events referred to part program execution:8 = BLOCK_BEG_1 Block start (first IPO cycle of a block)without intermediate blocks, all programlevels9 = BLOCK_BEG_2 and Block start (first IPO cycle of a block)with intermediate blocks, all program levels20 = BLOCK_BEG_2a10 = BLOCK_BEG_3 Block start (first IPO cycle of a block)without intermediate blocks, main programand MDA levels only16 = BLOCK_BEG_S1 and Block start (block search with calculation)with intermediate blocks, all program levels22 = BLOCK_BEG_S1a11 = BLOCK_END_1 Block end (first IPO cycle of a block)without intermediate blocks, all programlevels12 = BLOCK_END_2 and Block end (first IPO cycle of a block)with intermediate blocks, all program levels21 = BLOCK_END_2a13 = BLOCK_END_3 Block end (first IPO cycle of a block)without intermediate blocks, main programand MDA levels only17 = BLOCK_END_S1 Block end (block search with calculation)with intermediate blocks, all program levelsNon-cyclic events triggered by part program command WRTPR23 = PROT_TXT_REQ Logging of an WRTPR text24 = PROT_TXT_REQ_S1 Logging of an WRTPR text (block searchwith calculation)Non-cyclic events triggered by the logging operation itself14 = PROT_FILE_BEG Start of logging with reference to a log file.Non-cyclic events triggered by a tool25 = TOOL_CHANGE Tool change (as of SW 6.2)26 = CUTTEDGE_CHANGE Edge change (as of SW 6.2)27 = TOOL_CHANGE_S1 Tool change (block search with calculation)(as of SW 6.3)28 = CUTTEDGE_CHANGE_S1 Edge change (block search withcalculation) (as of SW 6.3)© Siemens AG, 2003. All rights reserved3-610 SINUMERIK 840D/840Di/810D SIMODRIVE 611 digital Lists (LIS) – 11.03 Edition