Barrel Heaters - Hasmak.com.tr

W A T L O WHot RunnerNozzle <strong>Heaters</strong>FIREROD CartridgeMade-to-OrderMounting OptionsMinimum No-HeatMinimum Unheated**Threaded FittingsThreaded fittings allow for fast,water-tight installation of the heaterinto a threaded hole. These fittingscan be ordered in either brass or304 stainless steel. Other stainlesssteel alloys are available uponrequest. Double threaded fittings arealso available.To order, specify either brass orstainless steel threaded fittings.Made-to-order, specify location fromdisc end to bottom of threads.Mounted at lead end, unless otherwisespecified and welded or silver soldered,depending upon construction.Made-to-Order AvailabilityFIRERODMinimumDiameterNo-Heatinches mm (in.)1⁄4 19 ( 3 ⁄4)3⁄8 25 (1)1⁄2 25 (1)5⁄8 25 (1)3⁄4 32 (1 1 ⁄4)Threaded Fittings SpecificationsFIREROD PipeDiameter Thread Fitting Lengthinches Size NPTF mm (in.)1⁄43⁄81⁄8 13 ( 1 ⁄2)1⁄4 17 ( 11 ⁄16)1⁄23⁄8 19 ( 3 ⁄4)5⁄81⁄2 22 ( 7 ⁄8)3⁄43⁄4 23 (1)1 1 25 (1)Injection MoldingHot Runner Nozzle <strong>Heaters</strong>1.6 mm (0.0625 in.)**HCDFlangesStainless steel flanges are aconvenient mounting method as wellas a way to position a heater withinan application. Standard location is6 mm (0.25 in.) from lead end;however, a specific location may berequested any place on theunheated section. Flanges can bestaked, soldered or welded.To order, specify flange, size andlocation.Flange SpecificationsFIRERODinchesDiameter Flangeinches Size D C H1⁄4, 3 ⁄8, 1 ⁄2 FS 1 3⁄4 0.1441⁄4, 3 ⁄8, 1 ⁄25⁄8, 3 ⁄4FM 1 1 ⁄2 1 1 ⁄8 0.1565⁄8, 3 ⁄4, 1 FL 2 1 1 ⁄2 0.2013.6 mm (0.140 in.)Locating RingA stainless steel locating ring can beused as a retaining collar to positiona FIREROD if mounting requirementsare not critical.To order, specify locating ring andlocation.Diameter inches: 3⁄81⁄25⁄83⁄4Ring O.D. inches: 5⁄83⁄47⁄8 189