Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
10 Programming Chart<br />
Programming Chart<br />
[System]<br />
[Methods]<br />
[Series]<br />
[Start/Stop]<br />
[Priority]<br />
[Hold/Cont.]<br />
Ready screen<br />
<br />
Perform<br />
standard<br />
wash<br />
Maintenance<br />
functions.<br />
System Settings<br />
1<br />
Copy<br />
methods<br />
Erase<br />
methods<br />
Midas<br />
logbook<br />
Serial<br />
communication<br />
protocol<br />
Control<br />
column oven<br />
temperature<br />
Control<br />
sample tray<br />
cooling<br />
<br />
Loop volume<br />
Needle volume<br />
Syringe volume<br />
Syringe speed<br />
Skip missing vials<br />
Air segment<br />
Headspace pressure<br />
Use calibration<br />
vials<br />
Method programming<br />
Tray type Inject marker pulse length<br />
Input edge next injection<br />
Freeze input active<br />
Reset outputs after last<br />
Series<br />
Service<br />
mode<br />
Device identifier Select Prep mode 2<br />
<br />
Injection type:<br />
<br />
Flush volume<br />
No injections/vial<br />
Analysis time<br />
Flush volume<br />
No injections/vial<br />
Injection volume<br />
Analysis time<br />
Method number<br />
First sample vial<br />
Last sample vial<br />
Use calibration vials 3<br />
First calibration vial<br />
Last calibration vial<br />
Vials between calibration<br />
First destination vial 4<br />
First Series<br />
Last Series<br />
<br />
Sample vial<br />
Hold the analysis time of the Midas<br />
Fig. 1 Programming chart<br />
No injections/vial<br />
Injection volume<br />
Analysis time<br />
Wash volume Timed events program: Mix program:<br />
Wash between:<br />
- Series<br />
- Vials<br />
- Series<br />
- 4 x AUX-1<br />
- 4 x AUX-2<br />
- INITIAL OVEN SETPOINT<br />
- 2 x OVEN SETPOINT<br />
- END TIME<br />
1. Available when the optional tray cooling is installed.<br />
2. When selecting the Prep mode, some system settings are no longer programmable, but set to a fixed value.<br />
3. Depends on the System Settings.<br />
4. In case Destination vials are used in the mix of the method.<br />
- Add<br />
- Mix<br />
- Wait