Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Operation 35<br />
General System Settings<br />
Press :<br />
GENERAL<br />
SYSTEM<br />
SETTINGS<br />
Volume of<br />
installed<br />
loop:<br />
Volume of<br />
tubing<br />
needle -><br />
valve:<br />
Syringe<br />
volume:<br />
Syringe<br />
speed:<br />
Skip missing<br />
vials:<br />
Range<br />
Comment<br />
0-5000 µl The volume of the installed loop.<br />
The AS <strong>3900</strong> uses this value for<br />
calculations of injection volumes.<br />
0-999 µl The volume of the tubing and needle<br />
connected to the injection valve.<br />
The AS <strong>3900</strong> uses this value for<br />
calculations of flush and transport<br />
volumes.<br />
The volume of the installed syringe.<br />
<br />
<br />
<br />
<br />
<br />
<br />
Air segment: <br />
<br />
Headspace<br />
pressure:<br />
<br />
<br />
The aspirating and dispensing<br />
speed are programmable in three<br />
steps:<br />
NORMAL for samples with a<br />
viscosity almost equal to the<br />
viscosity of water.<br />
LOW for samples with a higher<br />
viscosity and HIGH for samples with<br />
a lower viscosity compared to water.<br />
(See Table 4: Syringe speed.).<br />
Define if the AS <strong>3900</strong> has to stop if a<br />
vial is not found or continue with the<br />
next programmed vial.<br />
Program to stop the AS <strong>3900</strong><br />
in case a vial is not found.<br />
Inject a sample with or without an air<br />
segment between the sample and<br />
the wash solvent. If the air segment<br />
is ON (YES) the AS <strong>3900</strong> will draw<br />
an air segment of 5 µl before the<br />
flush volume prior to an injection.<br />
The air segment will not be injected<br />
in the analytical system.<br />
In case of µl pick-up the sample will<br />
be preceded by an air segment,<br />
which will be injected in the<br />
analytical system. (see page 18)<br />
The AS <strong>3900</strong> normally uses<br />
headspace pressure in combination<br />
with the syringe to transport sample<br />
in to the loop. If, for some reason, no<br />
headspace pressure is allowed, it<br />
can be switched OFF (NO). The<br />
compressor will always be used in<br />
the wash position of the AS <strong>3900</strong>.<br />
The accuracy and reproducibility of<br />
the AS <strong>3900</strong> can decrease when NO<br />
headspace pressure is used.