Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
46 Operation<br />
With the Next Injection Input AS <strong>3900</strong> will start the next injection in the<br />
Series. If the Series was completed, it starts the next injection from the<br />
next Series, until all Series have been completed.<br />
During the Run, AS <strong>3900</strong> shows the following information:<br />
STATUS: RUNNING TIME: 0:00:00<br />
SERIES:01 SAMPLE:01 INJ: 1/1 OVEN:--°C<br />
METHOD:01 TRAY:--°C<br />
r AUX: 12<br />
A blinking “r” in the lower left corner of the Run screen, indicates the AS<br />
<strong>3900</strong> is running in Remote Control mode.<br />
After completion of all Series the AS <strong>3900</strong> will display the following<br />
screen:<br />
SERIES COMPLETED VIA REMOTE CONTROL<br />
To return to the Ready screen press [Escape]. From the Ready screen<br />
the AS <strong>3900</strong> can be re-started by pressing the [Start/Stop] key.<br />
As long as the previous screen is displayed, it is not possible to restart<br />
the AS <strong>3900</strong> with a Next Injection Input.<br />
Priority sample<br />
For an emergency sample, AS <strong>3900</strong> offers the possibility to analyze it<br />
immediately without stopping the current Run.<br />
Press [Priority], to enter the priority-programming mode.<br />
Enter the position of the priority sample.<br />
PROGRAMMING PRIORITY<br />
PRIORITY SAMPLE: 12<br />
Return to the Run screen by pressing [Escape], the priority sample will<br />
be processed after the current sample has finished, with the method,<br />
which is running at the moment of entering the vial number.<br />
To indicate the priority sample has been activated, a blinking “p” is<br />
displayed in the Run screen.<br />
STATUS: RUNNING TIME: 0:00:00<br />
SERIES:01 SAMPLE:01 INJ: 1/1 OVEN:--°C<br />
METHOD:01 TRAY:--°C<br />
p AUX: 12<br />
As long as the “p” is blinking it is possible to change or remove the<br />
priority sample.<br />
The priority mode is only available during the execution of a Series<br />
with a method, which does NOT contain a Mix.