Smartline Autosampler 3900 Manual / Handbuch V 1508 03/2007

44 Operation
Should a method consist of only the wash and/or a timed events
program, no more questions will be asked.
When the use of calibration vials is enabled in the System Settings (See
page 34) and the method does not contain a mix, the AS 3900 will ask
the following questions:
Use calibration vials (see Fig. 36)
: • First calibration vial:
• Last calibration vial:
• No of samples between calibrations
The range of sample vials is:
• Last sample vial
• Last sample vial
When the method contains a mix item in which destination vials are used,
the AS 3900 will ask for the first position of the destination vials. The last
destination vial is calculated based on the sample vial range:
• First destination vial:
Fig. 36: Run sequence with 3 calibration vials between every 5 vials (First
calibration vial: 1, last calibration vial: 3 and number of samples between
calibrations: 5).
Sample vials and destination vials must be placed sequentially.
Sample vial and destination vial ranges must not overlap.
After all parameters are programmed return to the Series programming
screen by pressing [Escape], where an other Series can be
programmed. If all Series are programmed, return to the Ready screen
by pressing [Escape].
Series are not stored in battery backup memory.
After switching ON the Series are empty (method: ).