Digital Mailing System DM400,TM DM500TM and DM550TM

Mode Selection:
Attached Scale
- AutoTape
Mode Selection:
Seal Only
DM400, DM500, DM550 Operating Guide
Use this option if you want the system to automatically weigh and print a
tape as soon as you place a piece of mail on the scale.
Before using this weighing option:
• Set the scale to zero by pressing the Menu key, then selecting
Zero Scale.
• Make sure each piece of mail weighs at least as much as the amount
specified as the differential trip weight during the installation of your
mailing system. For more information, refer to the Set Up the Scale/
Select Rates:Diff Weigh Trip Weight section in Chapter 5 in this guide.
1. Press the Mode key.
2. Select Attached Scale - AutoTape.
3. The “Print Tape Automatically” screen appears.
4. Place each piece, one at a time on the scale. The system prints a tape
every time you place another piece of mail on the scale.
Use this mode if you just want to seal the envelopes and do not want to
apply postage.
1. Press the Mode key.
2. Select Seal Only and select the appropriate option. If you do not want
any of these options, go to step 3:
Reset Counter - Select this if you want to clear the number sealing
operations performed so far by your mailing system.
3. Place the mail on the feed deck.
4. Press the Start key.
NOTE: For additional sealing options, press the Seal key on the IntelliLink
Control Centre. This allows you to select the following options:
• Sealer on (seal envelopes)
• Sealer off
• Seal only, don’t print
SV61964 Rev. A 4-9