FTOS Command Reference for the S-Series - Force10 Networks

snmp-server host
Usage
Information
Example
Related
Commands
The following example specifies the group named harig as a version 3 user requiring both
authentication and encryption and read access limited to the read named rview.
snmp-server host
c e s Configure the recipient of an SNMP trap operation.
Syntax snmp-server host ip-address | ipv6-address [traps | informs] [version 1 | 2c | 3]
[auth | no auth | priv] [community-string] [udp-port port-number] [notification-type]
Parameters
Note: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP; TCP, ICMP rules
are not valid for SNMP. In IPv6 ACLs port rules are not valids for SNMP.
Force10#conf
Force10(conf)# snmp-server group harig 3 priv read rview
Force10#
Note: The number of configurable groups is limited to 16 groups.
show snmp group
Display the group name, security model, view status, and storage type
of each group.
show running-config snmp Display the SNMP running configuration
To remove the SNMP host, use the no snmp-server host ip-address [traps | informs]
[version 1 | 2c | 3] [auth | noauth | priv] [community-string] [udp-port number]
[notification-type] command.
ip-address Enter the keyword host followed by the IP address of the host
(configurable hosts is limited to 16).
ipv6-address Enter the keyword host followed by the IPv6 address of the host in the
x:x:x:x::x format.
The :: notation specifies successive hexadecimal fields of zero
traps (OPTIONAL) Enter the keyword traps to send trap notifications to the
specified host.
Default: traps
informs (OPTIONAL) Enter the keyword informs to send inform notifications to
the specified host.
Default: traps
114 SNMP and Syslog Commands