FTOS Command Reference for the S-Series - Force10 Networks

Related
Commands
show config
Figure 98 is an example unconfiguration of the hybrid port using the no portmode hybrid
command.
Figure 98 Unconfigure the hybrid port
show config
c e s View the interface configuration.
Syntax show config
Command Modes INTERFACE
Command
History
Example
Note: You must remove all other configurations on the port before you can remove
the hybrid configuration from the port.
Force10(conf-if-vl-20)#interface vlan 10
Force10(conf-if-vl-10)#no untagged gi 7/0
Force10(conf-if-vl-10)#interface vlan 20
Force10(conf-if-vl-20)#no tagged gi 7/0
Force10(conf-if-vl-20)#interface gi 7/0
Force10(conf-if-gi-7/0)#no portmode hybrid
Force10(conf-if-vl-20)#
show interfaces switchport
(S-Series)
Display the configuration of switchport (Layer 2) interfaces on the
switch (S-Series).
switchport Place the interface in a Layer 2 mode
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
Force10(conf-if)#show conf
!
interface GigabitEthernet 1/7
no ip address
switchport
no shutdown
Force10(conf-if)#
Figure 99 show config Command Example for the INTERFACE mode
FTOS Command Reference, version 7.6.1.0 245