FTOS Command Reference for the S-Series - Force10 Networks

mtu
Table 10 defines the menu options available.
mtu c e s Set the maximum Link MTU (frame size) for an Ethernet interface.
Syntax mtu value
Parameters
Defaults 1554
Command Modes INTERFACE
Command
History
Table 10 monitor Command Menu Options
Key Description
systest-3 Displays the host name assigned to the system.
monitor time Displays the amount of time since the monitor command was entered.
time Displays the amount of time the chassis is up (since last reboot).
m Change the view from a single interface to all interfaces on the line card or
visa-versa.
c Refresh the view.
b Change the counters displayed from Packets on the interface to Bytes.
r Change the [delta] column from change in the number of packets/bytes in the last
interval to rate per second.
l Change the view to next interface on the line card, or if in the line card mode, the
next line card in the chassis.
a Change the view to the previous interface on the line card, or if the line card mode,
the previous line card in the chassis.
T Increase the screen refresh rate.
t Decrease the screen refresh rate.
q Return to the CLI prompt.
To return to the default MTU value, enter no mtu.
value Enter a maximum frame size in bytes.
Range: 594 to 9252
Default: 1554
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
240 Interface Commands