FTOS Command Reference for the S-Series - Force10 Networks

seq c e s Assign a sequence number to a deny or permit filter in a MAC access list while creating the
filter.
Syntax seq sequence-number {deny | permit} {any | mac-source-address
[mac-source-address-mask]} [count [byte]] [log] [monitor]
Parameters
To remove this filter, use the no seq sequence-number command.
Defaults Not configured.
Command Modes MAC ACCESS LIST
Command
History
Related
Commands
sequence-number Enter a number between 0 and 65535.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition.
permit Enter the keyword permit to configure a filter to forward
packets meeting this criteria.
any Enter the keyword any to filter all packets.
mac-source-address Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-address-mask (OPTIONAL) Specify which bits in the MAC address must
match. If no mask is specified, a mask of 00:00:00:00:00:00 is
applied (in other words, the filter allows only MAC addresses
that match).
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
log (OPTIONAL) Enter the keyword log to log the packets.
monitor (OPTIONAL) Enter the keyword monitor to monitor traffic on
the monitoring interface specified in the flow-based monitoring
session along with the filter operation.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 7.4.1.0 Added monitor option
pre-Version 6.1.1.0 Introduced for E-Series
Note: When ACL logging and byte counters are configured simultaneously, byte
counters may display an incorrect value. Configure packet counters with logging
instead.
deny Configure a filter to drop packets.
permit Configure a filter to forward packets.
FTOS Command Line Interface Reference, version 7.6.1.0 353
seq