FTOS Command Reference for the S-Series - Force10 Networks

track
track c e s Monitor an interface and lower the priority value of the VRRP group on that interface if it is
disabled.
Syntax track interface [priority-cost cost]
Parameters
Defaults cost = 10
Command Modes VRRP
Command
History
Table 41 show vrrp Command Example Items (continued)
Authentication:... States whether authentication is configured for the VRRP group. If it is, the
authentication type and the password are listed.
Tracking states... This line is displayed if the track command is configured on an interface. Below
this line, the following information on the tracked interface is displayed:
• Dn or Up states whether the interface is down or up.
• the interface type slot/port information
To disable monitoring, use the no track interface command.
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback followed by a number
from 0 to 16383.
• For Port Channel interface types, enter the keyword port-channel followed
by the number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale
• For SONET interfaces, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by a number from 1 to
4094.
cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority
value.
Range: 1 to 254.
Default: 10.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
450 VRRP Commands