FTOS Command Reference for the S-Series - Force10 Networks

summary-address
summary-address
c e s Set the OSPF ASBR to advertise one external route.
Syntax summary-address ip-address mask [not-advertise] [tag tag-value]
Parameters
To disable summary address, use the no summary-address ip-address mask command.
Defaults Not configured.
Command Modes ROUTER OSPF
Command
History
Usage
Information
Related
Commands
Table 55 show ip ospf virtual-links Command Example Fields (continued)
Items Description
“Timer intervals...” This line displays the timer values assigned to the virtual link. The
timers are Hello is hello-interval, Dead is dead-interval, Wait is
transmit-delay, and Retransmit is retransmit-interval.
“Hello due...” This line displays the amount of time until the next Hello packet is
expected from the neighbor router.
“Adjacency State...” This line displays the adjacency state between neighbors.
ip-address Specify the IP address in dotted decimal format of the address to be
summarized.
mask Specify the mask in dotted decimal format of the address to be summarized.
not-advertise (OPTIONAL) Enter the keyword not-advertise to suppress that match the
network prefix/mask pair.
tag tag-value (OPTIONAL) Enter the keyword tag followed by a value to match on routes
redistributed through a route map.
Range: 0 to 4294967295
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
The command area range summarizes routes for the different areas.
With "not-advertise" parameter configured, this command can be used to filter out some
external routes. For example, you want to redistribute static routes to OSPF, but you don't
want OSPF to advertise routes with prefix 1.1.0.0. Then you can configure
summary-address 1.1.0.0 255.255.0.0 not-advertise to filter out all the
routes fall in range 1.1.0.0/16.
area range Summarizes routes within an area.
540 OSPF