FTOS Command Reference for the S-Series - Force10 Networks

match ip access-group
Parameters
Defaults No default behavior or values
Command Modes EXEC
Command
History
Usage
Information
EXEC privilege
E-Series Only Behavior
If a Policy QoS is applied on an interface when clear qos statistics is issued, it will clear
the egress counters in show queue statistics and vice versa. This behavior is due to the
values being read from the same hardware registers.
The clear qos statistics command clears both the queued and matched byte and packet
counters if the queued counters incremented based on classification of packets to the queues
because of policy-based QoS. If the queued counters were incremented because of some other
reason and do not reflect a matching QoS entry in CAM, then this command clears the
matched byte and packet counters only.
match ip access-group
c e s Configure match criteria for a class map, based on the access control list (ACL).
Syntax match ip access-group access-group-name [set-ip-dscp value]
Parameters
interface-name Enter one of the following keywords:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
To remove ACL match criteria from a class map, enter no match ip access-group
access-group-name [set-ip-dscp value] command.
access-group-name Enter the ACL name whose contents are used as the match criteria in
determining if packets belong to the class specified by class-map.
set-ip-dscp value (OPTIONAL) Enter the keyword set-ip-dscp followed by the IP DSCP
value. The matched traffic will be marked with the DSCP value.
Range: 0 to 63
Note: This option is not supported on S-Series.
Defaults No default behavior or values
548 Quality of Service