FTOS Command Reference for the S-Series - Force10 Networks

Defaults This command has no default behavior or value
Command Modes CONFIGURATION
Command
History
Example
Usage
Information
Related
Commands
Figure 89 define interface-range macro Command Example
interface range macro name
Figure 89 is an example of how to define an interface range macro named test. Execute the
show running-config command to display the macro definition as shown in Figure 89.
Applying the macro is shown in Figure 90.
interface range macro name
c e s Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax interface range macro name
Parameters
Defaults This command has no default behavior or value
Command Modes CONFIGURATION
Command
History
Usage
Information
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced
Force10(config)# define interface-range test tengigabitethernet 0/0 - 3 ,
gigabitethernet 5/0 - 47 , gigabitethernet 13/0 - 89
Force10# show running-config | grep define
define interface-range test tengigabitethernet 0/0 - 3 , gigabitethernet 5/0 - 47 ,
gigabitethernet 13/0 - 89
Force10(config)#interface range macro test
Force10(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
interface range Configure a range of command (bulk configuration)
interface range macro name Run an interface range macro.
name Enter the name of an existing macro.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced
Figure 90 runs the macro named test that was defined in Figure 89.
FTOS Command Reference, version 7.6.1.0 235