FTOS Command Reference for the S-Series - Force10 Networks

Defaults Disabled
Command Modes EXEC privilege
Command
History
Usage
Information
ip igmp querier-timeout
IGMP commands accept only non-VLAN interfaces—specifying VLAN will not yield a
results.
ip igmp querier-timeout
c e s Change the interval that must pass before a multicast router decides that there is no longer
another multicast router that should be the querier.
Syntax ip igmp querier-timeout seconds
Parameters
To return to the default value, enter no ip igmp querier-timeout.
Defaults 125 seconds
Command Modes INTERFACE
Command
History
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series legacy command
seconds Enter the number of seconds the router must wait to become the new querier.
Default: 125 seconds
Range: 60 to 300
Version 7.6.1.0 Introduced on S-Series in Interface VLAN mode only to enable that system to act
as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on C-Series in Interface VLAN mode only to enable that system to act
as an IGMP Proxy Querier.
E-Series legacy command
ip igmp query-interval
c e s Change the transmission frequency of IGMP general queries sent by the Querier.
Syntax ip igmp query-interval seconds
To return to the default values, enter no ip igmp query-interval.
FTOS Command Reference, version 7.6.1.0 567