FTOS Command Reference for the S-Series - Force10 Networks

ip route
ip route
c e s Assign a static route to the switch.
Syntax ip route destination mask {ip-address | interface [ip-address]} [distance]
[permanent] [tag tag-value]
Parameters
Note: This command is not supported on default VLAN (default vlan-id command).
To delete a specific static route, use the no ip route destination mask {address |
interface [ip-address]} command.
To delete all routes matching a certain route, use the no ip route destination mask
command.
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in slash prefix formation (/x) of the destination device’s IP
address.
ip-address Enter the IP address in dotted decimal format of the forwarding router.
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a loopback interface, enter the keyword loopback followed by a
number from zero (0) to 16383.
• For the null interface, enter the keyword null followed by zero (0).
• For a Port Channel interface, enter the keyword port-channel followed
by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale.
• For a SONET interface, enter the keyword sonet followed by the sonet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
distance (OPTIONAL) Enter a number as the distance metric assigned to the route.
Range: 1 to 255
permanent (OPTIONAL) Enter the keyword permanent to specify the route is not
removed, even if the interface assigned to that route goes down. The route must
be up initially to install it in the routing table.
If you disable the interface with an IP address associated with the keyword
permanent, the route disappears from the routing table.
tag tag-value (OPTIONAL) Enter the keyword tag followed by a number to assign to the
route.
Range: 1 to 4294967295
414 IP Routing Commands