FTOS Command Reference for the S-Series - Force10 Networks

set weight
set weight
c e s Configure a filter to add a non-RFC compliant attribute to the BGP route to assist with route
selection.
Syntax set weight weight
Parameters
To delete a weight specification, use the no set weight weight command.
Defaults router-originated = 32768; all other routes = 0
Command Modes ROUTE-MAP
Command
History
Usage
Information
If you do not use the set weight command, router-originated paths have a weight attribute of
32768 and all other paths have a weight attribute of zero.
show config
c e s View the current route map configuration.
Syntax show config
Command Modes ROUTE-MAP
Command
History
Example
weight Enter a number as the weight to be used by the route meeting the route map
specification.
Routes with a higher weight are preferred when there are multiple routes to the
same destination.
Range: 0 to 65535
Default: router-originated = 32768; all other routes = 0
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Force10(config-route-map)#show config
!
route-map hopper permit 10
Force10(config-route-map)#
Figure 130 show config Command Example
FTOS Command Line Interface Reference, version 7.6.1.0 385