FTOS Command Reference for the S-Series - Force10 Networks

• Remove the interface from the passive list.
• The ABR status for the router is updated.
redistribute
• If passive-interface default is specified, then save no passive-interface interface
into the running configuration.
No passive-interface default
• Clear everything and revert to the default behavior.
• All previously marked passive interfaces are removed.
• May update ABR status.
redistribute
c e s Redistribute information from another routing protocol throughout the OSPF process.
Syntax redistribute {connected | rip | static} [metric metric-value | metric-type type-value]
[route-map map-name] [tag tag-value]
Parameters
To disable redistribution, use the no redistribute {connected | isis | rip | static}
command.
Defaults Not configured.
Command Modes ROUTER OSPF
Command
History
connected Enter the keyword connected to specify that information from active
routes on interfaces is redistributed.
rip Enter the keyword rip to specify that RIP routing information is
redistributed.
static Enter the keyword static to specify that information from static routes is
redistributed.
metric metric-value (OPTIONAL) Enter the keyword metric followed by a number.
Range: 0 (zero) to 16777214.
metric-type
type-value
(OPTIONAL) Enter the keyword metric-type followed by one of the
following:
• 1 = OSPF External type 1
• 2 = OSPF External type 2
route-map map-name (OPTIONAL) Enter the keyword route-map followed by the name of
the route map.
tag tag-value (OPTIONAL) Enter the keyword tag followed by a number.
Range: 0 to 4294967295
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
FTOS Command Reference, version 7.6.1.0 513