FTOS Command Reference for the S-Series - Force10 Networks

show ip ospf topology
Example
Related
Commands
• The LSU Q length and its highest mark for each neighbor
• The LSR Q length and its highest mark for each neighbor
Figure 187 show ip ospf statistics Command Example
show ip ospf topology
c e s Display routers in directly connected areas.
Syntax show ip ospf topology
Defaults No default values or behavior
Command Modes EXEC
Command
History
Usage
Information
Force10#show ip ospf statistics
Interface GigabitEthernet 0/8
Hello-Timer 9, Wait-Timer 0, Grace-Timer 0
Error packets (Only for RX)
Intf-Down 0 Non-Dr 0 Self-Org 0
Wrong-Len 0 Invld-Nbr 0 Nbr-State 0
Auth-Error 0 MD5-Error 0 Cksum-Err 0
Version 0 AreaMisMatch 0 Conf-Issue 0
SeqNo-Err 0 Unkown-Pkt 0
Neighbor ID 9.1.1.2
Hello DDiscr LSReq LSUpd LSAck
RX 59 3 1 1 1
TX 62 2 1 0 0
Dead-Timer 37, Transmit-Timer 0
LSU-Q-Len 0, LSU-Q-Wmark 0
LSR-Q-Len 0, LSR-Q-Wmark 1
clear ip ospf statistics Clear the packet statistics in all interfaces and neighbors
EXEC privilege
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series
This command can be used to isolate problems with inter-area and external routes. In OSPF
inter-area and external routes are calculated by adding LSA cost to the cost of reaching the
router. If an inter-area or external route is not of correct cost, the display can determine if the
path to the originating router is correct or not.
538 OSPF