FTOS Command Reference for the S-Series - Force10 Networks

show ip traffic
Related
Commands
show ip traffic
c e s View IP, ICMP, UDP, TCP and ARP traffic statistics.
Syntax show ip traffic [all | cp | rp1 | rp2]
Parameters
Command Modes EXEC privilege
Command
History
Table 36 show ip route summary Column Headings
Column Heading
Description
Route Source Identifies how the route is configured in FTOS.
Active Routes Identifies the best route if a route is learned from two protocol sources.
Non-active Routes Identifies the back-up routes when a route is learned by two different
protocols. If the best route or active route goes down, the non-active route
will become the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised,
then information on those routes is displayed.
Total 1388 active ... Displays the number of active and non-active routes and the memory usage
of those routes.
If there are no routes configured in the FTOS, this line does not appear.
show ip route Display information about the routes found in switch.
all (OPTIONAL) Enter the keyword all to view statistics from all processors.
If you do not enter a keyword, you also view all statistics from all processors.
cp (OPTIONAL) Enter the cp to view only statistics from the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route
Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route
Processor 2.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.5.1.0 F10 Monitoring MIB available for ip traffic statistics
pre-Version 6.1.1.0 Introduced for E-Series
434 IP Routing Commands