FTOS Command Reference for the S-Series - Force10 Networks

show ip ssh rsa-authentication
c e s Display the authorized-keys for the RSA authentication.
Syntax show ip ssh rsa-authentication {my-authorized-keys}
Parameters
Defaults No default behavior or values
Command Modes EXEC
Command
History
Example
Usage
Information
Related
Commands
Figure 73 show ip ssh rsa-authentication command
This command displays the contents of the file flash:/ADMIN_DIR/ssh/
authorized-keys.username.
show ip ssh rsa-authentication
ssh c e s Open an SSH connection specifying the hostname, username, port number and version of the
SSH client.
Syntax ssh {hostname | ipv4 address | ipv6 address} [-l username | -p port-number | -v {1 | 2}]
Parameters
my-authorized-keys Display the RSA authorized keys.
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Force10#show ip ssh rsa-authentication my-authorized-keys
ssh-rsa
AAAAB3NzaC1yc2EAAAABIwAAAIEAyB17l4gFp4r2DRHIvMc1VZd0Sg5GQxRV1y1X1JOMeO6Nd0WuYyzrQMM
4qJAoBwtneOXfLBcHF3V2hcMIqaZN+CRCnw/
zCMlnCf0+qVTd1oofsea5r09kS0xTp0CNfHXZ3NuGCq9Ov33m9+U9tMwhS8vy8AVxdH4x4km3c3t5Jvc=
freedom@poclab4
Force10#
ip ssh rsa-authentication (Config) Configure the RSA authorized keys.
hostname (OPTIONAL) Enter the IP address or the hostname of the remote device.
ipv4 address (OPTIONAL) Enter the IP address in dotted decimal format A.B.C.D.
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format followed by
the prefix length in the /x format.
Range: /0 to /128
Note: The :: notation specifies successive hexadecimal fields of zeros
FTOS Command Reference, version 7.6.1.0 213