FTOS Command Reference for the S-Series - Force10 Networks

Usage
Information
vlan-stack compatible
Prior to enabling this command, you must enter the switchport command to place the
interface in Layer 2 mode.
To remove the access port designation, the port must be removed (using the no member
interface command) from all Stackable VLAN enabled VLANs.
vlan-stack compatible
c e s Enable the Stackable VLAN feature on a VLAN.
Syntax vlan-stack compatible
To disable Stackable VLAN on a VLAN, enter no vlan-stack compatible.
Defaults Not configured.
Command Modes VLAN
Command
History
Usage
Information
Version 7.6.1.0 Support added for C-Series and S-Series
E-Series original Command
You must remove the members prior to disabling the Stackable VLAN on the VLAN.
To view the Stackable VLANs, use the show vlan command in the EXEC privilege mode.
Stackable VLANs contain members, designated by the M in the Q column of the command
output.
Force10#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Gi 13/13
M Gi 13/0-2
3 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/3
4 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/4
5 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/5
Force10#
Figure 116 show vlan Command Example with Stackable VLANs
FTOS Command Line Interface Reference, version 7.6.1.0 303