FTOS Command Reference for the S-Series - Force10 Networks

track ip
Command Modes INTERFACE VLAN
Command
History
Usage
Information
Related
Commands
When you use the no tagged command, the interface is automatically placed in the Default
VLAN as an untagged interface unless the interface is a member of another VLAN. If the
interface belongs to several VLANs, you must remove it from all VLANs to change it to an
untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong
to one VLAN at a time.
track ip
c e s Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member
interfaces.
Syntax track ip interface
Parameters
To remove the tracking feature from the VLAN, use the no track ip interface command.
Defaults Not configured
Command Modes INTERFACE VLAN
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
interface vlan Configure a VLAN.
untagged Specify which interfaces in a VLAN are untagged.
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed
by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale.
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
286 Layer 2