FTOS Command Reference for the S-Series - Force10 Networks

ip ospf retransmit-interval
Use this command for interfaces connected to multi-access networks, not point-to-point
networks.
ip ospf retransmit-interval
c e s Set the retransmission time between lost link state advertisements (LSAs) for adjacencies
belonging to the interface.
Syntax ip ospf retransmit-interval seconds
Parameters
Defaults 5 seconds
Command Modes INTERFACE
Command
History
Usage
Information
To return to the default values, enter no ip ospf retransmit-interval.
Set the time interval to a number large enough to prevent unnecessary retransmissions. For
example, the interval should be larger for interfaces connected to virtual links.
ip ospf transmit-delay
c e s Set the estimated time elapsed to send a link state update packet on the interface.
Syntax ip ospf transmit-delay seconds
Parameters
Defaults 1 second
seconds Enter the number of seconds as the interval between retransmission.
Range: 1 to 3600.
Default: 5 seconds.
This interval must be greater than the expected round-trip time for a packet to
travel between two routers.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
To return to the default value, enter no ip ospf transmit-delay.
seconds Enter the number of seconds as the transmission time. This value should be
greater than the transmission and propagation delays for the interface.
Range: 1 to 3600.
Default: 1 second.
FTOS Command Reference, version 7.6.1.0 509