FTOS Command Reference for the S-Series - Force10 Networks

Example
Figure 188 show ip ospf topology Command Example
show ip ospf virtual-links
show ip ospf virtual-links
c e s Display the OSPF virtual links configured and is useful for debugging OSPF routing
operations. If no OSPF virtual-links are enabled on the switch, no output is generated.
Syntax show ip ospf virtual-links
Command Modes EXEC
Command
History
Example
Force10#show ip ospf topology
Router ID Flags Cost Nexthop Interface Area
3.3.3.3 E/B/-/ 1 20.0.0.3 Gi 13/1 0
1.1.1.1 E/-/-/ 1 10.0.0.1 Gi 7/1 1
Force10#
EXEC privilege
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Force10#show ip ospf virt
Virtual Link to router 192.168.253.5 is up
Run as demand circuit
Transit area 0.0.0.1, via interface GigabitEthernet 13/16, Cost of using 2
Transmit Delay is 1 sec, State POINT_TO_POINT,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:02
Force10#
Figure 189 show ip ospf virtual-links Command Example
Table 55 describes the information displayed in Figure 189.
Table 55 show ip ospf virtual-links Command Example Fields
Items Description
“Virtual Link...” This line specifies the OSPF neighbor to which the virtual link was
created and the link’s status.
“Run as...” This line states the nature of the virtual link.
“Transit area...” This line identifies the area through which the virtual link was
created, the interface used, and the cost assigned to that link.
“Transmit Delay...” This line displays the transmit delay assigned to the link and the
State of the OSPF neighbor.
FTOS Command Reference, version 7.6.1.0 539