FTOS Command Reference for the S-Series - Force10 Networks

spanning-tree mstp edge-port
spanning-tree mstp edge-port
c e s Configures the interface as an Multiple Spanning Tree edge port and optionally a Bridge
Protocol Data Unit (BPDU) guard.
Syntax spanning-tree mstp edge-port [bpduguard]
Parameters
Command Modes INTERFACE
Command
History
Usage
Information
On an MSTP switch, a port configured as an edge port will immediately transition to the
forwarding state. Only ports connected to end-hosts should be configured as an edge port.
Consider an edge port similar to a port with spanning-tree portfast enabled.
tc-flush-standard
c e s Enable the MAC address flushing upon receiving every topology change notification.
Syntax tc-flush-standard
Defaults Disabled
Command Modes CONFIGURATION
Command
History
mstp edge-port Enter the keywords mstp followed by the keyword edge-port to
configure the interface as a Multiple Spanning Tree edge port.
bpduguard (OPTIONAL) Enter the keyword bpduguard to prevent the port
from participating in the active STP topology in case a BPDU shows
up on a port unintentionally, is misconfigured, or subject to a DOS
attack. This option places the port into an error disable state if a
BPDU appears, and a message is logged for the administrator to take
corrective action.
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 6.1.1.0 Support for BPDU guard added
To disable, use the no tc-flush-standard command.
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 6.5.1.0 Introduced
FTOS Command Line Interface Reference, version 7.6.1.0 487