FTOS Command Reference for the S-Series - Force10 Networks

Command Modes ROUTE-MAP
match route-type
c e s Configure a filter to match routes based on the how the route is defined.
match route-type
Syntax match route-type {external [type-1 | type-2] | internal | level-1 | level-2 | local}
Parameters
To delete a match, use the no match route-type {local | internal | external [type-1 |
type-2] | level-1 | level-2} command.
Defaults Not configured.
Command Modes ROUTE-MAP
Command
History
Related
Commands
external [type-1| type-2] Enter the keyword external followed by either type-1 or
type-2 to match only on OSPF Type 1 routes or OSPF Type
2 routes.
internal Enter the keyword internal to match only on routes
generated within OSPF areas.
level-1 Enter the keyword level-1 to match IS-IS Level 1 routes.
level-2 Enter the keyword level-2 to match IS-IS Level 2 routes.
local Enter the keyword local to match only on routes generated
within the switch.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match interface Redistribute routes that match the next-hop interface.
match ip address Redistribute routes that match an IP address.
match ip next-hop Redistribute routes that match the next-hop IP address.
match ip route-source Redistribute routes that match routes advertised by other routers.
match metric Redistribute routes that match a specific metric.
match tag Redistribute routes that match a tag.
FTOS Command Line Interface Reference, version 7.6.1.0 375