FTOS Command Reference for the S-Series - Force10 Networks

anner exec
• show inventory (S-Series) on page 86
• show memory (S-Series) on page 87
• show processes cpu (S-Series) on page 88
• show processes ipc flow-control on page 90
• show processes memory on page 92
• show software ifm (S-Series) on page 95
• show system (S-Series) on page 96
• show tech-support (S-Series) on page 98
• telnet on page 100
• terminal length on page 100
• traceroute on page 101
• undebug all on page 103
• write on page 103
banner exec
c e s Configure a message that is displayed when another user enters the EXEC privilege mode.
Syntax banner exec c line c
Parameters
To delete a banner, enter no banner exec.
Defaults No banner is enabled.
Command Modes CONFIGURATION
Command
History
Example
c Enter the keywords banner exec, and then specify a character delineator,
represented here by the letter c, and press ENTER.
line Enter a text string for your banner message ending the message with your
delineator.
In the example in Figure 17, the delineator is a percent character (%); the banner
message is “testing, testing”.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
Force10(conf)#banner exec %
Enter TEXT message. End with the character '%'.
testing, testing%
Force10(conf)#
Figure 17 banner incoming Command Example
66 Control and Monitoring Commands